Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Company in Sunset, FL
Garage door installation in Sunset, FL almost always comes back to one question: does the door meet Miami-Dade wind-load code? Most of the 1960s and 1970s ranch homes and villa communities in 33173 still have their original single-car doors, and those thin-gauge steel panels were never built for the pressure a named storm puts on a garage opening. We replace them with NOA-approved, wind-rated units sized correctly for the opening, and we handle the full job from removing the old track to programming the opener. Coral Gables Garage Door Service has served Sunset since 2014, and our repair-first approach means we only propose a new door when the existing one can’t economically be brought up to standard. Call (855) 752-9022 for a free estimate on any door project in Sunset.
Why Sunset Homes Are Different
Sunset sits squarely inside Miami-Dade’s hurricane evacuation zone, so the garage door here is the single most scrutinized opening on the house. Nearly every installation or repair in 33173 gets judged against Miami-Dade NOA/product-control approval and wind-load requirements rather than cosmetics. That is a standard a garage door technician working in Orlando or Tampa never has to think about. Around here, it is the first question an inspector, an insurance underwriter, or a buyer’s agent asks.
The housing stock drives a lot of what we see. Sunset is dominated by block-and-stucco ranch homes built between the 1960s and 1980s, plus low-rise townhome and villa communities. The original doors on those older homes are frequently single-car wood or thin 24-gauge steel. They bend under wind pressure, their panels delaminate after decades of afternoon sun, and their tracks pull out of the jamb. We routinely swap them for code-compliant doors that carry the right Miami-Dade NOA number for the exact opening size.
Climate matters here in a different way than in colder parts of Florida. We get no hard freeze, but we do get salt-laden air off Biscayne Bay, months of 90-degree humidity, and a June-through-November storm season. Steel doors and hardware corrode year-round. Rollers get gritty. Bottom seals turn brittle. We replace rollers, hinges, and seals in Sunset far more often than any inland technician would consider normal.
Styles & brands we work with
Our Main Sunset Services
The two calls we take most often in Sunset are for broken springs or cables on existing doors, and for openers that have stopped responding or only run partway. Both get answered by the same crew that handles our full installations, so the person at your door understands the whole system, not just one component.
Garage Door Repair in Sunset
Springs snap, cables fray, and tracks drift out of alignment on a regular cycle in Sunset, especially on older doors that have been through a few storm seasons. A door that won’t open leaves a car trapped in the garage, and in 33173 the heat makes that a real problem for groceries, medication, and school runs. We repair the full range of issues with parts matched to the existing brand and door weight. Garage Door Repair in Sunset covers spring replacement, cable work, panel repair, track realignment, and roller replacement, all quoted before work begins.
Garage Door Opener Repair in Sunset
Opener failures in Sunset follow a predictable pattern: the drive gear strips, the logic board fails after a brownout, or the safety sensors get knocked out of alignment by humidity-swollen door frames. Multi-brand fluency means we diagnose and repair the opener brand you already own, whether it’s a belt, chain, or screw drive. We do not push a replacement opener when a capacitor or limit switch is the actual fix. Garage Door Opener Repair in Sunset walks through the most common openers we fix in 33173 and what the job involves.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Garage Door Installation in Sunset
Garage door installation in Sunset is a code-compliance job first and a style choice second. The older ranch homes here were built with single-car openings that often measure a non-standard 8 by 7 feet, while many villa communities have arch-top or recessed openings that require a custom panel arrangement. Whatever the configuration, the new door has to carry a Miami-Dade NOA approval for that exact size and pressure rating, and it has to be installed with the right track gauge, jamb reinforcement, and header brackets so the whole assembly holds together under negative pressure.
Because we are a full-service garage door specialist rather than a single-brand dealer, we approach each Sunset installation as a system decision: the right Clopay, Amarr, or Wayne Dalton door for the wind-load requirement, paired with an opener from a brand we service daily. The full scope of what we install is covered on our Garage Door Installation page. In Sunset, we size the door to the rough opening, not the other way around, and we quote every line item before ordering anything.
Garage Door Replacement
Signs you need it
A door that has rusted through at the bottom rails, delaminated at the panel joints, or bowed inward under pressure is past economical repair.
What it costs in Sunset
New door installation in Sunset typically runs $700 to $2,200, with panel replacement as a smaller job at $250 to $500 per panel when the track and hardware are still sound.
How we do it
We remove the old door and track, inspect the jambs for rot or pulled anchors, install the new wind-rated door with reinforced brackets and a no-sag track assembly, then balance and cycle-test the finished installation.
Garage Door Installation Service
Signs you need it
You have a new rough opening, a converted carport, or a door that was installed by a previous owner without a Miami-Dade product approval document on file.
What it costs in Sunset
A full garage door installation service in Sunset falls in the $700 to $2,200 range depending on door size, wind-load rating, insulation, and window options.
How we do it
We measure the opening and wall condition, recommend a NOA-approved door matched to the exposure rating for your specific Sunset block, order the exact unit, and install the door, track, springs, and opener as one system.
Garage Door Seal Installation
Signs you need it
Daylight is visible under a closed door, the bottom seal has cracked and separated, or you are finding debris and water on the garage floor after every storm.
What it costs in Sunset
A new bottom seal, side weatherstrip, or full seal kit in Sunset is priced within the panel replacement range of $250 to $500 when installed as part of a door service call.
How we do it
We pull the old seal, clean the retaining channel, cut a new bulb or T-style seal to the full width of the door, and re-seat the track so the seal compresses evenly from corner to corner.
What Garage Door Installation Costs in Sunset
| Item | Typical range in Sunset |
|---|---|
| New door installation | $700 – $2,200 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
Does a new garage door in Sunset have to be Miami-Dade approved?
Yes. Any door or replacement panel installed on a home in Sunset must carry a Miami-Dade NOA or Florida product approval covering wind load for that exact size and exposure, or it will not pass inspection, insurance review, or resale certification.
Can you replace a Sunset garage door during hurricane season?
We schedule installation work all year, though the late-season weeks fill fast for post-storm replacements. The key is having your opening measured and the product ordered early, since wind-rated doors are built to order and lead times stretch after a named storm.
Brands We Service in Sunset
Sunset homeowners own a mix of door and opener brands, and we work on the brand you already have. That includes Clopay, Amarr, and Wayne Dalton doors, plus openers from LiftMaster, Chamberlain, Genie, and Craftsman. Our trucks carry common rollers, hinges, sensors, and seal stock for these lines, so a spring or roller replacement usually happens in one visit. For specifics, see our brands.
See the difference
Before
After
Before
After
Before
AfterPricing for Garage Door Company in Sunset, FL
| Service | Typical range in Sunset |
|---|---|
| Spring repair | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
| General garage door repair | $150 – $600 |
Prices in Sunset run higher when the door is an odd size, when the opening needs structural reinforcement for wind code, or when the existing hardware is too corroded to reuse. Your price is quoted and agreed before any work starts, so the number on the invoice is the number you approved.
Neighborhoods We Serve in Sunset
We cover the full 33173 zip code, including the ranch-home streets around Southwest 72nd Street, the villa communities north of Sunset Drive, and the townhome clusters near Southwest 87th Avenue. Because we’re based in Coral Gables and work Sunset daily, we can usually reach most addresses in the area quickly when a door will not close.
- Sunset Knoll
- Sunset Villas
- West Sunset
- Continental Park area, 33173
- Snapper Creek villas
Service Area – Cities Near Sunset
Beyond Sunset, Coral Gables Garage Door Service covers the surrounding southwest Miami-Dade corridor. We work regularly in Olympia Heights, FL, Westwood Lake, FL, Richmond Heights, FL, and Kendale Lakes, FL, bringing the same wind-code knowledge and multi-brand parts stock to each.
Serving Sunset, FL — Our Local Coverage Area
We’re based in the Sunset area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Garage Door Company in Sunset
We prioritize calls where a door is stuck open or a car is trapped inside. Most Sunset addresses in 33173 are within a short dispatch from our Coral Gables base, and we carry common springs, rollers, and opener parts on the truck so many repairs are finished on the first trip.
Many villa and townhome communities in Sunset have architectural guidelines that cover door color, panel style, and sometimes approved brands, so check your association’s rules before ordering. We provide the specs, wind-load documentation, and product numbers your HOA will want.
Yes. We install and service commercial-grade sectional doors and operators for small retail, warehouse, and condo association properties in Sunset, including the wind-rated products required for commercial openings. Call (855) 752-9022 to schedule a site visit for a free estimate.
For a free estimate on any garage door job in Sunset, call Coral Gables Garage Door Service at (855) 752-9022. The price we quote is the price you pay, and no work begins until you approve it.
What happens when you call
- 1A real person answersNo phone trees — talk to a local garage door pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Sunset Customers Say
"Fixed the spring properly and the door works fine. He did leave the old spring and some hardware by the side of the house, and I had to text to ask about hauling it off. They came back for it, just took a couple of days."
— Elena Rodriguez"Logic board on a 15 year old opener. He was upfront that a new opener would cost less than the board plus labor, and he wasn't wrong. No pressure either way."
— Allison Schaefer"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
— Bethany Barrett